E3D Titan Test

Read Article →
Time to install the new Titan extruders.  The original extruder design was all-metal, but this time I'd like to incorporate some prin...
Posted by : Ryan
0 Comments

Assembly VIII: Side Panels

Read Article →
I'd like to clean up the printer a bit before working on the extruders, so I decided to install the side panels.  The side panels serve...
Posted by : Ryan
0 Comments

Extruder Investigation

Read Article →
I plan on addressing the extruder banding problem by replacing the entire extruder assembly, but first I'd like to investigate the so...
Posted by : Ryan
0 Comments

First Prints

Read Article →
I'm not a huge fan of testing complex projects because probability makes it quite likely that something will go wrong.  That being sa...
Posted by : Ryan
1 Comments

Assembly VII: Extruder Wiring

Read Article →
The final assembly task is to connect the extruder wiring to the Smoothieboard.  I did this in a slightly roundabout way so that it will b...
Posted by : Ryan
0 Comments

Assembly VI: Final Alignments

Read Article →
I spent quite a bit of time getting the electronics running, so its finally time to bring the mechanical side of the printer up to speed ...
Posted by : Ryan
0 Comments

Contact

Name

Email *

Message *